MIXER SAMSON S6 AMPLIFICATO DA 6 CANALI CON EQUALIZZATORE

Descrizione

• 6 balanced mic/line-input channels.
• Independent CD/tape input; signal is routed via
channel EQ.
• Power: 200 watts into 4 ohms.
• Built-in 3-spring reverb.
• 3-band equalization on all channels.
• 10-band graphic master EQ.
• Master peak LED.
• Input trim control on each channel.
• 2 Aux sends per channel.
• 2 Aux returns with front-panel level controls.
• 48 V phantom power selectable for mic input
connectors.
• Protection relay circuitry to prevent noise when
powering on.
• 2 speaker outputs.
• Portable format with carry handle and protective
corners.
• Rackmountable with rack ears included.
• Rear-panel amp in and preamp output.
• Master monitor and reverb level controls

MIXER/PREAMP SECTION
THD (with 30 kHz LPF, trim center): < 0.01%
Signal-to-noise ratio (with 30 kHz LPF, trim center): 78 dB
Maximum voltage gain
Mic in to preamp out: effects send 1, 2, mon out: 62 dB
Line in to preamp out: effects send 1, 2, mon out: 52 dB
Tape in to preamp out: effects send 10 dB
Tape return to preamp out: 2:5 dB
Residual noise (with 30 kHz LPF, VR min)
Preamp out: -115 dB
Mon out: -100 dB
Trim gain: 40 dB
Tone controls
High (10 kHz): ± 15 dB
1 kHz: ± 12 dB
Low (80 Hz): ± 15 dB
Graphic equalizer (30, 64, 125, 250, 500 Hz, 1, 2, 3, 5, 10 kHz): ± 15 dB
Peak LED: 5 dB before clipping
Tape input sensitivity (-10 dB): 300 mV
POWER AMP SECTION
Rated output power (1 kHz): 200 W into 4 ?
130 W into 8 ?
THD (with 30 kHz LPF): < 0.0035%
Signal-to-noise ratio (with 30 kHz LPF): 110 dB
Frequency response (±1 dB): 10 Hz to 28 kHz
Input sensitivity/impedance: 1.2 V/10 k?
Residual noise (VR min): 74 dB typical
Idle current (across the 0.47 ? emitter resistor): < 7 mA
DC offset voltage: 0 ± 50 mV
GENERAL
Dimensions: 19" (w) x 4.92" (d) x 11.02" (h)
51 mm (w) x 125 mm (d) x 280 mm (h)
Weight: 29 lb. • 13.2 kg
Power requirements: 115 VAC • 50/60 Hz
376 W (115 VAC)
Power consumption (at full power): 395 W (230/240 VAC


FUNZIONANTE
Qualche difetto esetico